I ran MS Exchange Pre-Deployment Analyzer (ExPDA) on my Windows 7, and got this warning message below.
Googled and found the the solution below,
1. Open Registry Editor.
2. Locate HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\RESvc\Parameters.
3. Right-click Parameters and select New | DWORD value. Name the new DWORD value SuppressStateChanges.
4. Double-click SuppressStateChanges.
5. In the Value data field, enter 1.
6. Close Registry Editor and then restart the Simple Mail Transfer Protocol (SMTP) service, the Microsoft Exchange Routing Engine service, and the Microsoft Exchange MTA Stacks services for the change to take effect. (Thanks for this good article.)
Subscribe to:
Post Comments (Atom)
Solution: The size of the extent is less than the minimum in VMware
I ran out the C drive space in a Windows 10 virtual machine in VMware. However, after adding additional free disk space, the "Extend&q...
-
This has been a frequent seen issue in our environment. The common symptoms are: After a Word or Excel file open, or when trying to save...
-
Recommended by a very knowledgeable Xerox technician - perform this procedure once a month Unplug both Ethernet and power cable for 5 fu...
-
If you have received the following errors when running the ACL scripts, "The ordinal xxxx could not be located in the dynamic link libr...
No comments:
Post a Comment